-20 pts ยท October 15, 2020
Didn't install the software that came on the sd card. I just created a new profile in Cura which is what I use for my other printer.
Pics are of a part fix for defective z-motor bracket. Check out this thread https://www.reddit.com/r/ender3/comments/m0irm1/ender_3_v2_setup
Yes, cannabis
Didn't install the software that came on the sd card. I just created a new profile in Cura which is what I use for my other printer.
Pics are of a part fix for defective z-motor bracket. Check out this thread https://www.reddit.com/r/ender3/comments/m0irm1/ender_3_v2_setup
Yes, cannabis